FANUC SYSTEM

Q1: Spindle speed deceleration

SYSTEM → Input 4030 → NO.SRH → 04030 S1 → ______   ← change this value (Default3000or3500)

Q2: G41、G42Moving path as expected

G41, G42 in the program must not contain G00 (rapid displacement), that the cutting-point must be made before G41, G42 move to positioning.

Q3: Auto, MDI Mode MDI mode switch is set to maintain the relative coordinates

SYSTEM → Input 5003→NO.SRH→5003.7 the 0 change to 1
 
SYSTEM→Input5006→NO.SRH→5006.3The 0 change to 1

Q4: The lubrication execute time

SYSTEM → PMCMNT → Right-looking "Timer" → No.21 → _____  ← Designation change this value (or default setting to 15 seconds to perform 15,000 milliseconds)

Q5: The lubrication execution interval time

SYSTEM→ PMCMNT→ Right-looking "Counter" → No.2 → _____  ← designation change this value (or default setting to 450 seconds interval 450 that is executed once, Unit：seconds.)

Q6: Cutting cycle diagonal retraction and vertical retraction

SYSTEM → Input1401 → NO.SRH → 1401.1 →______  ← set this value 0 for vertical retraction, set this value1 for diagonal retraction.
 
SYSTEM → Input1401 → NO.SRH → 5108.1 →______  ← set this value 0 for vertical retraction, set this value 1 for diagonal retraction.

Q7: Machine home point return

The model is rotated to Zero mode → press the X axis → pressing Z axis (Zero must first perform X-axis).

Q8: Alert EX1029

In without using tailstock state, the quill isn’t completely retracted, if quill is completely retracted, it can be solved.

Q9: AlarmSV0401 (X) IMPROPER V_READY OFF / SV0401 (X) IMPROPER V_READY OFF

X-axis, Z axis servo motor voltage is not delivered properly. Turn the machine off, check the electrical lower right corner of the box "circuit protection device (similar to the switch without fuse) if there is blackout and Cause not supply power to the servo motorcorrectly.
If not resolved, check the line for every axis is breaking or blackout. Also contact Fanuc sales service department for assistance.

Q10: Alarm SP9021 (S) Position sensor error setting.

Check the belt tension or slipping.
For more parameter settings, please refer to Electronically Controlled and FANUC's manual

MITSUBISHI SYSTEM

Q1: Maintenance mode of the tool turret

Enter the handwheel mode and click MONITOR and PLC switch in order, select "Engineering Mode of Tool Turret" to turn on the mode setting, then click the axial buttons on the operation panel to extend or retract the tool turret.
For more parameter settings, please refer to Electronically Controlled and MITSUBISHI's manual
TOP